hal: Enable USB Service Interval Config
Enabling service interval configuration allows toggling of
burst mode for USB RX path for all use cases other than
ULL and voice call (assuming compatible USB audio hardware).
Backend reconfiguration will occur when burst mode feature
is enabled while entering/exiting voice call/ULL.
Change-Id: Ide1f6e9945ae4ba9be2d5f16fac321c661e1d90b
diff --git a/hal/msm8974/platform.c b/hal/msm8974/platform.c
index ca36adf..8b4ba5e 100644
--- a/hal/msm8974/platform.c
+++ b/hal/msm8974/platform.c
@@ -2266,7 +2266,6 @@
ALOGD("ACDB initialization failed");
}
}
-
/* init keep-alive for compress passthru */
audio_extn_keep_alive_init(adev);
#ifdef DYNAMIC_LOG_ENABLED
@@ -5952,6 +5951,8 @@
unsigned int bit_width;
unsigned int sample_rate;
unsigned int channels;
+ unsigned long service_interval = 0;
+ bool service_interval_update = false;
bool passthrough_enabled = false;
bool voice_call_active = false;
int backend_idx = DEFAULT_CODEC_BACKEND;
@@ -6100,6 +6101,27 @@
audio_extn_usb_is_config_supported(&bit_width, &sample_rate, &channels, true);
ALOGV("%s: USB BE configured as bit_width(%d)sample_rate(%d)channels(%d)",
__func__, bit_width, sample_rate, channels);
+
+ if (audio_extn_usb_get_service_interval(true,
+ &service_interval) == 0) {
+ /* overwrite with best altset for this service interval */
+ int ret =
+ audio_extn_usb_altset_for_service_interval(true /*playback*/,
+ service_interval,
+ &bit_width,
+ &sample_rate,
+ &channels);
+ ALOGD("%s: Override USB BE configured as bit_width(%d)sample_rate(%d)channels(%d)SI(%lu)",
+ __func__, bit_width, sample_rate, channels, service_interval);
+ if (ret < 0) {
+ ALOGW("Failed to find altset for service interval %lu, skip reconfig",
+ service_interval);
+ return false;
+ }
+ service_interval_update = audio_extn_usb_is_reconfig_req();
+ audio_extn_usb_set_reconfig(false);
+ }
+
if (channels != my_data->current_backend_cfg[backend_idx].channels)
channels_updated = true;
}
@@ -6138,7 +6160,7 @@
// is not same as current backend comfiguration
if ((bit_width != my_data->current_backend_cfg[backend_idx].bit_width) ||
(sample_rate != my_data->current_backend_cfg[backend_idx].sample_rate) ||
- passthrough_enabled || channels_updated) {
+ passthrough_enabled || channels_updated || service_interval_update ) {
backend_cfg->bit_width = bit_width;
backend_cfg->sample_rate = sample_rate;
backend_cfg->channels = channels;